Board Foot Calculator Desktop Header Logo
Kalkulator BD FT
Insulation Specialist

Kalkulator Insulasi Board Foot

Hitung board feet, luas cakupan, dan jumlah bahan insulasi glasswool, rockwool, dan busa berdasarkan ketebalan dan nilai R.

Insulation Calculator

Calculate board feet and coverage area for insulation materials

Common Insulation Sizes:

Fiberglass Insulation

Most common type. R-value typically 3.14 per inch. Available in batts (pre-cut) or rolls. Standard widths: 14.5" (for 16" OC studs) and 22.5" (for 24" OC).

Rigid Foam Board

Higher R-value per inch (R-5 to R-6.5). Common sizes: 4'×8' sheets in 1", 1.5", and 2" thickness. Excellent for continuous insulation applications.

Spray Foam

Highest R-value (R-6 to R-7 per inch for closed-cell). Sold by board foot coverage. One board foot covers 1 sq ft at 1" thick. Expands to fill gaps.

Pertanyaan yang Sering Diajukan

How do I calculate insulation coverage?
Multiply width (in feet) × length (in feet) to get square footage. For board feet, multiply thickness (inches) × width (inches) × length (feet) ÷ 12.
What R-value do I need?
Depends on climate zone and application. Walls typically need R-13 to R-21, attics R-30 to R-60. Check local building codes for requirements.
How many board feet in a spray foam kit?
Common kits: 200 BF, 600 BF. One board foot covers 1 square foot at 1 inch thick. For 2" thickness, divide coverage by 2.

How to work out board feet for insulation, in plain words

Formula: board feet = (thickness in inches x width in inches x length in feet) / 12. That is the same board foot formula used for lumber, applied to insulation pieces. For spray foam, one board foot also means one square foot covered at one inch thick, which is why spray foam kits are often sold by board feet.

Worked example: take a fiberglass batt 3.5 inches thick, 14.5 inches wide, and 8 feet long, in a quantity of 20 pieces. Per piece: (3.5 x 14.5 x 8) / 12 = 33.83 board feet. For 20 pieces: 33.83 x 20 = 676.67 board feet. Coverage from the same pieces is (14.5 / 12) x 8 x 20 = 193.33 square feet, and total R-value is 3.5 x 3.14 = 10.99, about R-11, which matches the fiberglass batt preset on this page.

Common mistakes: using the stud spacing width instead of the batt width, forgetting that board feet and square feet are different units, and using nominal thickness instead of the actual batt thickness. Check the batt label for thickness and width before you enter numbers.

Waste factor: allow 5 to 10 percent extra for cuts around studs, pipes, and outlets, and for offcuts that are too short to reuse. For a 676.67 board foot order, 10 percent extra is 67.67 board feet, giving a buying total of about 744 board feet. Spray foam waste is lower than batt waste, but allow extra for overspray and trimming.

When to use this method: use this calculator when you are buying batts, rigid foam boards, or spray foam by board feet, or when you need to compare R-value and coverage for the same wall area. Use the wall calculator instead when you need stud counts and wall framing first, and use the main board foot calculator for plain lumber without an R-value.

Related insulation calculators

These three tools cover the next step after insulation board feet: spray foam coverage, wall framing area, and plain board feet without R-value.